English
Arabic
Chinese
Dutch
Finnish
French
German
Hebrew
Hindi
Italian
Japanese
Korean
Polish
Portuguese
Russian
Spanish
Swedish
gmeltveit@gmail.com
gmeltveit@gmail.com
About
- Username
- gmeltveit@gmail.com
- Joined
- Visits
- 14
- Last Active
- Roles
- Verified User
- Posts
- 9
Comments
-
https://forum.ftecu.com/uploads/591/BUUPPMH1O9W2.jpg https://forum.ftecu.com/uploads/525/CPZ441OIPXAM.jpg I have tested it on a stand. Did a realt test ( or what you can do without a dyno or beeing on track) Did 90 shifts and worked fine. So maybe i…
-
Yes. It is working fine in the garage on the pit stand. But on track it stops working after 2-3 rounds around the track. I have checked the diagnostics on the bike and everything is fine. Also it shows a steady 0.3 on the ohm test all the way up to …
-
This happend again. Was working fine and then after i started to push it stopped working. Did some checking and it shows 0.3 on the ohmn test. Also the pins on the ECU are firmly in place and also give a signal (ohm test). The blipper is working fin…
-
Hi I am trying to flash this file: https://forum.ftecu.com/uploads/723/9KUDILTX7O68.png This file is matching my ECU. There is no problem reading the file from the ECU, it is only when I try to write. I will make another attempt to be 100% sure that…
-
did a test again. First the QS only, shows 0.3 steady. Connected the blipp harness, shows steady 0.3. Disconnected ECU and checked, steady 0.3. Aslo tested the green wire, test OK. As you know I have a blipp harness, and just to make sure it is a si…
-
Hi I have done the 6 pin test and, no fuel pump starting and also did the voltmeter test, showing steady 5.05 voltage.
-
Hi I did a ohm test step by step, first only the QS, and then the split cabel, and then it did a ohm test on the pins in the ECU connector. Also did the test and tried to force the error, maybe thinking it was a bad connection or some loose wires, b…