English
Arabic
Chinese
Dutch
Finnish
French
German
Hebrew
Hindi
Italian
Japanese
Korean
Polish
Portuguese
Russian
Spanish
Swedish
nullscan@gmail.com
nullscan@gmail.com
About
- Username
- nullscan@gmail.com
- Joined
- Visits
- 26
- Last Active
- Roles
- Verified User
- Posts
- 6
Comments
-
Well it took the flash this morning, still rough and stalled out once just after I started it. Start to get a weird tremor at about 3.5k through my right peg. I still smell unburnt gas at stop lights. If the PNs are the same, there shouldn't be a di…
-
I'll try it again, but last time I tried I was getting codes about not having enough licenses from the software. I'm on Korea time so it'll be a bit before I get back to it. Thanks.
-
https://forum.ftecu.com/discussion/comment/3710#Comment_3710 Reading instructions is fundamental, I didn't notice that both connectors to my ECU had white 'unlocking' tabs for the pins, and sure enough I had missed that part of the installation.
-
I am, the yellow and orange will snug in but are pretty easily pulled back. Red is loose but I think just because of the angle and the other wires I can't push it in as far. I know there are plastic pin inserters from making serial cables in the pas…
-
I'm having a hell of a time getting the red/yellow/orange pins all the way inserted on my MT-10. I push until the wire bends and it doesn't make enough of a connection for the software to talk to the ECU. Looking into the connector I see all the fa…