DTC after ECU flash
Being bored during winter time as this is very simple I connected GSXR 1000, 2020 Diag connector vi BT to Android Torque Pro app just being curious what can I see from that app and to check eventual fault codes if any.
Regardless this byke use CAN bus for different modules communication, for DIag it is K-Line.
Scanning Fault codes from Torque app showed 4 DTC and I was wondering how this is possible after reflashing ECU with map 17-19 GSXR1000 - 32920-17KG2(EU) Unrestricted as from my understanding by ECU Flash DTC code also are erased.
No to be misleaded there are no errors on byke Dash and byke works normal but just Torque scan show these Fault codes.
Sure from FT UI O2, PAIR and EXCVA are disabled and HW removed as I have full Akra exhaust and PAIR is removed where block off plates are installed.
No worries but wondering how these errors are stored after ECU flash as all devices from Screenshot are disabled by FT?