todd@ftecu.com
todd@ftecu.com
About
- Username
- todd@ftecu.com
- Joined
- Visits
- 226
- Last Active
- Roles
- Staff User
- Posts
- 102
Comments
-
This means you have encountered an issue during the writing process and have tried to recover the same license too many times. The system will flag the activity and prevent writing for a period of time. It is similar to trying to log in to somethi…
-
depends on your ecu pn, is it a carry over from a previous year etc...
-
Those two options are not available on your bike.
-
99% of the time it is hardware issue with the wiring of the harness or power supply. Are you bike side or bench side flashing? Search the forums here for bench harness testing and bike harness testing to help troubleshoot.
-
resolved.
-
resolved.
-
Check the forums for bike side harness test. Your harness is not wired properly or one or more of the pins are not making contact to the pins of the ecu when plugged in.
-
Understand, this is for the next time you have an issue, take a picture and send to sales@ftecu.com
-
have you resolved this issue?
-
Please try the stock file.
-
issue resolved thru email
-
Issue resolved thru email.
-
Not all bikes have Active tune feature. What bike do you have?
-
looks like issue is resolved?
-
Please do not flash files that do not match your ecu pn.
-
We do not offer anything like that.
-
I have looked at all the licenses you list and time frames of when things happened and I am not sure what exactly is going on. When you get another instance please email sales@ftecu.com with a screen capture of the message that shows on the screen …
-
Look in the file under Ignition/ idle control.
-
Yes, as long as they are both 6pin you only need to get the bike specific harness and a new license.
-
When you try again start with nothing connected to the ecu. it should ask if you wish to assign RECOVERED license, click yes. Please let me know if that is not the case.
-
Will do
-
If one is being prompted for a license, it could be because: There is an intermittent connection in the bench or bike side program harness. (Check the wiring) After a confirmed write, at the end not physically disconnecting the ecu before attempti…
-
please provide a picture of your sensor.
-
Thank you for pointing this out, I will pass this information on to R&D
-
from the website for the 2017-2020 Yamaha R6 Racing Electronics Kit This kit is intended for and fully compatible with the GYTR/YEC Race kit harness (not included).
-
Sorry, I do not have any recommendations for your track.
-
If you purchased the autoblip activation license and you have the quickshift hardware installed on your bike, then you just need to activate the feature in the file and reflash the ecu. If you were not the one that flashed the ecu, then you will ha…
-
Sorry, we do not have any support for that bike.
-
The A-tune sequence used in the controller follows Bosch's recommendations.
-
You picked a good place to start. You will not be able to modify the Graves file, as they lock out the fuel mapping, (protects their hard dyno time work). If you find that it does not meet your needs you can always contact a dealer from our dealer…