English
Arabic
Chinese
Dutch
Finnish
French
German
Hebrew
Hindi
Italian
Japanese
Korean
Polish
Portuguese
Russian
Spanish
Swedish
stigma@xmsnet.nl
stigma@xmsnet.nl
About
- Username
- stigma@xmsnet.nl
- Joined
- Visits
- 28
- Last Active
- Roles
- Verified User
- Posts
- 15
Comments
-
I am doing ok again at the moment but, it was a close call. Thanks for the support. This thread can be closed.
-
No longer necessary. My bike and myself got written off. https://0297.nl/nieuws/80440/motorrijder-aangereden-op-n201-mijdrecht
-
I have been reading thru post (not model specific) and i notice that for at least 3 weeks there have been no replies from FTEcu anywhere. Are you all sick or on holiday or...?
-
So i recrimped my ground wire and now its 4.99V on both wires. Shorting Red and orange does not ignite the pimp. Shorting red and yellow does trigger the punp 3 clicks and then nothing. So i tried to flash and the flash just stopped half way. Had to…
-
I just measured the ground (black cable), it has 1.6Ohms with key off. 11.4 Ohms with key on. Continuity is 015 with key on (no clue what it is but i thought i would mention it) The black wire has been soldered to the bikes ground wire because the p…
-
So i checked the troubleshooter guide for the 6 pin connector. It fails on short-circuiting red/orange and red/yellow (pump jiggles off and on) https://photos.app.goo.gl/5nJz5vZnuYoXB52D8 https://photos.app.goo.gl/q3JuwVDP9geqasuJ9 black/orange sho…
-
activating the switch by pulling the lever to go up. When i say nothing happens, i mean that the circuit does not close. For now the problem has been "fixed". When i dissembled the QS, i dropped it. After i brought it in the house it all of a sudden…
-
https://forum.ftecu.com/discussion/comment/371#Comment_371 RN22 R1, but i fail to see how that is related to a possible defective switch. I can't close the circuit on the push and/or pull side. (btw, users can't edit their posts, so since i submitt…
-
Have found a bug! If you press on extended:"warmup idle" and use the cursor to go up in the list, all values will show as "false". When you click on one of the values directly, it will show as the correct value (true when it set as "true")
-
It's 02:00pm here now. I am not in the position to test the software yet, however the download section is back online so that means the back-end should be available again. Also, what i have seen is that the current version and the revision history o…
-
I asked for a constructive reply on how we can help ourselves in the future. Not why the server is down. We can see it's down..