English
Arabic
Chinese
Dutch
Finnish
French
German
Hebrew
Hindi
Italian
Japanese
Korean
Polish
Portuguese
Russian
Spanish
Swedish
blkvice
blkvice
About
- Username
- blkvice
- Joined
- Visits
- 230
- Last Active
- Roles
- Verified User
- Posts
- 21
Comments
-
Its working now Virtualbox seems to be the culprit.
-
https://forum.ftecu.com/discussion/comment/4200#Comment_4200 I did try downloading and installing the driver but it seems that isnt the problem since when I click register it sees the usb cable. I dont know what else to try. Hope you can help
-
https://forum.ftecu.com/discussion/comment/4184#Comment_4184 There’s actually no error message. I type my email/pass hit login and it just stays there greyed out can’t even close the program had to crt alt del to quit.
-
It’s an old obdII reader Tonwon obdII pro wifi. I tried some new obdII reader but those doesn’t work.
-
Alright it's working again thank you
-
Thank you very much
-
https://forum.ftecu.com/discussion/comment/3246#Comment_3246 Try also turning off the firewall I did that as well when I flashed the ecu. btw using virtualbox fyi
-
https://forum.ftecu.com/discussion/comment/3235#Comment_3235 got mine to finally work wired the laptop to the router so I guess it was the wifi that’s causing the problem. The only trouble is I had to get a 30ft cable just so I could connect the lap…
-
you can try. https://forum.ftecu.com/discussion/comment/3235#Comment_3235
-
https://forum.ftecu.com/discussion/comment/3170#Comment_3170 I did as instructed it stop at 10% on the first try then 2nd time it finish to 100% but still says no ECU found. Should I try flashing using the stock map first? btw writing to ecu would f…
-
Hi got an “flash init” again and no ecu registered found. Don’t know what im doing wrong it was working just fine before. Should I flash the ecu with unrestricted map without enabling auto blipper and activetune first? Could you please reset my li…
-
Same issue ECU not found everytime I try to write. Status "flash init" please help It was working already then this happened. Account email: blkvice@gmail.com
-
Thank you very much.
-
Thanks, I actually found the answer on the R1 board. By the way it says in the document to ground the pin to the battery (the one you have to remove on the ecu harness). Does that mean if I want the AIS to still function?