Comments

• https://forum.ftecu.com/discussion/comment/3050#Comment_3050 I followed your advice and tried flashing again with a fresh brand new file. (B34-8591A-00 in Stock ECU Images folder) QS has never worked before. The version before Nov 4 had issue: Bike…

  in Problem quickshifter mt07 Comment by Thomas April 2021
• Hello Martin here reported this issue in Nov 2019 and ended up selling his bike because of this. My bike has been on the side-stand since Aug 2020 because of this. Other customers on this forum has reported the same issues and it has not been sol…

  in Problem quickshifter mt07 Comment by Thomas April 2021
• I tested the quickshifter sensor with a multimeter. It seems fine. Closes the loop when shifting as it should. Just to rule out other possible causes; Is the pins correct on the wire harness from the qs (picture) that connects to the side harness? …

  in Problem quickshifter mt07 Comment by Thomas April 2021
• Hi Jason I tried the new file as you suggested today. This made it worse. Without even touching the shifter, the bike started the bouncing moves (Engine goes On/Off/On/Off) right on the "Minimum RPM" set in the app was reached, followed by check eng…

  in Problem quickshifter mt07 Comment by Thomas April 2021
• Hi Please send me the reset file for MT 07 (B34-8591A-00)

  in VERY IMPORTANT: Please make sure you are flashing the correct file! Comment by Thomas August 2020
• https://forum.ftecu.com/uploads/788/OQV7E6Y98A1H.png Hi I have the same problem after installing the quickshifter today. When quickshifting, bike shift gear, then bike dies, massive engine breaking. wake up after 1 second, then full throttle follo…

  in Problem quickshifter mt07 Comment by Thomas August 2020
• Hi I want to tune the ignition tables manually based on the stock tables as I was not happy about the results I got after using the "unrestricted" file. I really need clear any doubt about the (Cylinder/Gear) map index before I start. The map index…

  in About IGN Map. MT-07 Comment by Thomas August 2020