Support Forum

Chrck Engine Light after Bike Side Harness Install

drentmendoza@yahoo.comdrentmendoza@yahoo.com Posts: 7Verified User

Recently installed a bike side harness for my EX400. Followed all the instructions down to the last detail. Flashed the bike and it was successful. The engine runs but the CEL is on. I found the following errors:

11

12

13

1C

3A

64


Do you have a fix for this?

Comments

  • jason@ftecu.comjason@ftecu.com Posts: 1,071Staff User

    Hi,

    What is your ECU part number?

    What file did you flash it with?

    Are you starting the bike with the USB still plugged into the bike side harness?

    Thanks,

    Jason A.

  • drentmendoza@yahoo.comdrentmendoza@yahoo.com Posts: 7Verified User

    Hi Jason,


    I used a 1314 ECU and flashed it with an Unrestricted file from your database. I also removed the USB before starting the bike.

    Thanks,


    Drent M.

  • kento_ftecukento_ftecu Posts: 776Staff User

    The fact that all those codes suddenly showed up sounds like the file part number that was flashed didn't match the ECU part number.

  • drentmendoza@yahoo.comdrentmendoza@yahoo.com Posts: 7Verified User

    I'm pretty sure that I used the correct file. Anyway, I'll try to reflash it again and give you an update on this. 👌


    Thanks!

  • ron_kristyn@hotmail.comron_kristyn@hotmail.com Posts: 1Verified User

    I am having the same problem. I used the correct ECU file. Cant get anyone on the phone or email. Pretty frustrated at this point

Sign In or Register to comment.