Hardware test for autoblipper switch state in FTECU Tuning Suite?

boyracer081@gmail.com

Hi There,

Is it possible to see the auto-blipper push/pull sensor contact state (open/closed state of the two switches) from within the FT ECU tuning suite software and observe changes when the switches are operated?

Would be handy to test the switch, wiring and all pin out connections are made correctly and testing how much pressure is required on the shift linkage to test if the switch is actuating, can test with an ohm-meter easily the switch, however would like to see the binary input change state as indicated by the ECU so you know that the signal is fully complete.

Would also be handy after bike is crashed (Hey, it happens to the race bikes!) before sending the bike back on track to know that the push/pull sensor has not been damaged and rearset/linkage has been fixed, not much good finding out on the warm-up lap that your quickshifter/auto-blipper circuit has a problem.

Regards,

Byron.

jason@ftecu.com

Hi,

Thank you for your input, I will forward your idea on and see what the main developer's thoughts are on it.

Thanks,

Jason A.