Trouble with flash on CP3

contact@fb-racing.fr

Hello, first connection today with my BS2-8591A-00 (EU) ECU. After many attempts and some after flash validation issues, flash was finaly correct with a stock BS2-8591A-10 (US) Map and running was good and ignition coil relocation on hardness.

Next step, was to reflash with active tune fonctionality on, i'have good various error messages : license not valid, Ecu not registered, or freeze at the end of flash.

I cheched my FT additional wiring with no problem...

Thanks for help and sorry for my bad english. Loïc

kento_ftecu

Hi, your license was in "attempted" state because of a problem during the flash process. Either you had a poor internet connection(or it dropped out during the process), or the hardware wasn't making a complete connection. We have reset your license so you should be able to flash again.

contact@fb-racing.fr

Hi, thank you for reply,

it's possible my internet connection wasn't good enough. I will make an other flash attempt in few days and make a feedback to you about result.

Regards. Loïc

contact@fb-racing.fr

Thank you for license reseting, poor internet connection was my problem. Flash is ok now.

Regards, Loïc.