Support Forum

Preparing the bike for the flash

barbaros_kok@msn.combarbaros_kok@msn.com Posts: 4Verified User
in FZ / MT 10

Hi,

I have purchased my kit for my 2017 Mt-10 Sp , I will use the unrestricted map . I read the document about the connection . Before I put my hands on it , do I have to remove the O2 sensors or can I leave them on the bike as disabled ? Because I am gutting the cat ,I cant use a Y-pipe because of sound regulations in my country are soo strict .Somewhere I read that I have to remove the right O2 sensor ,do I have to ?

I must finish this procedure as smooth as I can because no one has any knowledge about flashing a bike or solving problems about it here, if you have any tips that I can get , I will be very grateful ..


Thank you ..

Tagged:

Comments

  • jason@ftecu.comjason@ftecu.com Posts: 1,071Staff User

    Hi,

    The removal of the O2 sensors is not necessary, however it is recommended. If you don't have a plug for your exhaust at least unplug the O2 sensor from its connection to the bike harness but leave it in your exhaust.

    Thanks,

    Jason A.

  • barbaros_kok@msn.combarbaros_kok@msn.com Posts: 4Verified User

    Thank you very much for your reply ..

Sign In or Register to comment.