Stuck on "Requesting ECU ID"
I just tried flashing a costumers MT09 2017 and was not able to do so.
I prepared the file, connected the cable, everything is ok and recognised.
When I press write ECU, a pop up says to connect the ECU ON, so I turn on the power and plug the cable to the ecu, It then says "Requesting ECU ID" and won´t progress, it just stays there.
Normally it would take only a few seconds for the pop up to buy a new license.
Is maybe this a bug in the new software?
I tried in my pc running W7 and then on a laptop with W10, same problem.