How to Test Your Quickshift Sensor Using a Multimeter
charlie@ftecu.com
Posts: 30Staff User
Hey,
For this test, you will need a multimeter.
The easiest and quickest way to test your quickshift sensor is to check whether the internal switch is activating properly.
Step 1: Leave the quickshift sensor installed on the motorcycle.
Step 2: Locate both connectors coming from the sensor and disconnect them from the wiring harness.
Step 3: Set your multimeter to measure resistance (Ω) or continuity.
Step 4: On one of the sensor connectors, place each multimeter probe against each of the two terminals/pins. You may need to use small wires or paper clips to make contact with the terminals. Be careful not to damage or spread the terminals.
Step 5: Apply pressure to the shift lever in the direction that should activate the sensor:
- Red/Yellow connector (Pull): Move the shift lever in the direction that causes the sensor to extend or be pulled apart.
- Blue/Green connector (Push): Move the shift lever in the direction that causes the sensor to compress.
Step 6: Watch the multimeter while applying pressure. When the sensor activates, you should see continuity or the resistance drop to approximately 0 Ω.
Step 7: Release the pressure and repeat the test several times. The sensor should consistently switch between an open circuit (OL or very high resistance) and a closed circuit (approximately 0 Ω).
Step 8: Repeat the same procedure on the other connector, applying pressure in the opposite direction.
Interpreting the results
- Normal operation: The resistance drops to approximately 0 Ω when the sensor is activated and returns to an open circuit when released.
- No continuity: If the resistance never drops when pressure is applied in the correct direction, the sensor may be faulty.
- Intermittent operation: If the resistance fluctuates, continuity cuts in and out, or the sensor only activates occasionally, there may be an internal switch or wiring issue.
- Excessive activation force: If the sensor requires unusually high force to activate, it may not be triggering reliably during normal shifting. Check your shift setup.
- Constant continuity: If the sensor reads approximately 0 Ω even without pressure, the switch may be stuck closed.
If the sensor consistently switches between an open circuit and approximately 0 Ω with reasonable pressure, it is likely functioning correctly electrically.
In any case where you think the sensor may be faulty, please reach out to us at sales@ftecu.com for further testing and troubleshooting.
English
Arabic
Chinese
Dutch
Finnish
French
German
Hebrew
Hindi
Italian
Japanese
Korean
Polish
Portuguese
Russian
Spanish
Swedish