Support Forum

Random start and erratic dash codes

paulsidiro@gmail.compaulsidiro@gmail.com Posts: 4Verified User
edited February 2023 in ZX 10

Hi folks,

My 2013 Zx10r, just got the 4 wire bike harness installed. Before that, I made sure the battery was charged and the bike started and ran.

After the unrestricted flash, the bike would not start. Then I tested the interface and the dash codes went away and it started. It ran for a minute, I shut it off and then would NOT start again.

I did the harness check, black/red is 12.9volts, black/green is 10volts, black/yellow shows 4.7volts and NO fuel pump priming.

the test interface, ignition on/off shows test input (1) and ECU unplugged shows test input. (0)

Also the dash is flashing after the ECU flash, it did not do that before.

Any recommendations??



Comments

Sign In or Register to comment.