Support Forum

Auto Blipper don't work on my 2017 MT10

kuey996@hotmail.comkuey996@hotmail.com Posts: 4Verified User
in FZ / MT 10

Hi , followed the instruction to intall the auto blipper quickshifter kit, and ensable the auto bliper on bench

it's work ok on upshift ,but downshift no blip, any other way can go wrong?

My ECU is B67-8591A-00

Tagged:

Comments

  • octavio@ftecu.comoctavio@ftecu.com Posts: 191Staff User
    edited May 2022

    Hi,

    Can you send me pictures of your install please?

    Also what account are you flashing with?

    Regards

  • kuey996@hotmail.comkuey996@hotmail.com Posts: 4Verified User

    Hi

    My bike run the gp shifter,and done with smog block off plates

    The first ,I had test the shift sensor signal output up and down are all right , and adjusted the connect rod make sure up and down shiftting on the same pressure on sensor

    The second problems, I have that I bought the wrong of auto blipper kit,it's for FZ10, not for MT10, the plug is square no the round one,

    It's okay I had modified it to round one and plug in the pin 12 of the smail row coupler

    (I was concerned it's possible the resistance of the plug is different , make the signal too weak?cus I joined the round plug and green wire by solder)

    I did tried to write it back to stock mapping ,enable the auto blipper, not working still

    And Wrote it back to the unrestricted mapping, auto blip not working still

    Let me know what either I can do? I alread done what I can do! These are hardware issue or software issue?

    The worst part I'm not on state, and took me so much time to keep trying, not really happy at all...




  • octavio@ftecu.comoctavio@ftecu.com Posts: 191Staff User
    edited May 2022

    Hi,

    Did you put the wire you took out from the larger 3 row connector back in? Also since you are in GP shift have you swapped the QS sensor connectors as well?

    Regards

  • kuey996@hotmail.comkuey996@hotmail.com Posts: 4Verified User

    Hi

    Since I modified put in small 4 row connector didn't work,I had tried plug in the pin 2 of larger 4 row connector (The FZ10 style),but the fuel pump didn't work when ignition on

    I did tried swapping the QS sesnor connectors when the auto blip didn't work on the way I took for test ride(No up quicklshift and no blipping after swapping)

    I checked around the hardware,any chance I did wrong

    And now I put it back in small 4 row connector(the MT10 style) , I still wait for good news from you

  • octavio@ftecu.comoctavio@ftecu.com Posts: 191Staff User

    Hi

    Does the pin you put in match exactly? And Auto Blip is enabled for certain?

    You may need a new AB harness.

    Regards

  • kuey996@hotmail.comkuey996@hotmail.com Posts: 4Verified User
    edited May 2022

    Hi

    You give me a light,I almost give up

    I zoom in the graphic of the MT10 auto blipping kit

    Finailly,I got the answer,the ab harnesses are different between MT&FZ, not just different on the green wire of auto blipping

    A little tough up the FZ type of harness,it was a long journey of try and error,it blipped eventually😭

    Cheers

  • octavio@ftecu.comoctavio@ftecu.com Posts: 191Staff User

    Hi,

    Glad you were able to work something out.

    Regards

Sign In or Register to comment.