Autoblip

foqua24@yahoo.com

The QS works fine, but the autoblip stopped working. Everything seems good from a connectivity standpoint, and the software shows it's Enabled. Possible the sensor needs replacing??? Is there something I'm missing?

Thanks in advance... JB

kento_ftecu

Please conduct a continuity test on your sensor connector responsible for the auto-blip. You will probably need to use safety wire or small sewing pins to use as jumpers so that your multimeter test probes will make contact with the tiny female pins in the JST connector. Connect the two pins in the connector, you should see/hear continuity when you move the shift lever firmly into the downshift movement.