Trying to Flash and keep getting " No Registered ECU found . Would you like to purchase a license "
Is there a bug
The software did log an issue with the license for your 08-11 R6. The license has been reset and you can now reflash your ECU again.
Just tried to Re-flash "failed no response " indicated
You have a hardware problem that is preventing connection with your ECU. Please refer to the pinned post regarding the hardware test at the top of the forum.
hey. I have same problem too. I keep receiving same messages. "no registered ECU found. would you like to purchase a license for this ECU"
please help me . thanks
What type of harness are you using, bench or bike-side?
bench type. i have 2018 cbr1000rr sp.
im Having the same issue. done one flash and went to do a flash with a few changes and says my licence is owned by someone else.
Please check your hardware. With bench harness, check continuity with a tester. With bike-side harness, use the hardware test sticky post on the forum homepage.
I have the same problem
What type harness are you using?
Have seen this no license found issue when using bench harness where there is an issue with the power supply... check that your power supply is providing 12V between red and black pins of the ECU plug
Hi. I also have the same problem. I keep getting the same messages. "Registered ECU not found. do you want to buy a license for this ECU ”please help. thanks
What bike are you flashing?
Are you bike side flashing or bench flashing? What harness number are you using?
What is your ECU part number?
First time on a bench, second time after mounting qs on a bike. Later try again on the bench. Yamaha Mt 09 2014
2014-2017 Yamaha FZ-09 ECU-based Quickshifter Kit
1 $240.00 $240.00
2014-19 Yamaha FZ / MT-09 Data Link Bench ECU Flashing Kit (Intl.)
1 $460.00 $460.00
6-Pin Bike Side Harness Type 11
1 $49.95 $49.95
Dodam that once worked without any problem. After installing qs and the side harness can not in any way.
What are you saying worked no problem?
The first time everything worked. The second time an error occurred.
Did you try flashing it on the bike and bench harness? Are you connecting power or keying on before prompted to? Usually hardware problems or not following software prompts causes license recognition issues.
I tried on a bicycle harness and it didn't work out, then I tried on a bench and it didn't work out either. I followed the hints. As I said, the first time everything went without complications.
I tried again and I succeeded. I hope that the problem will not recur. I have another question. How long does it take to buy a new license before it appears on your account?
If you order a single license it should add automatically into your account so you can start flashing immediately.
I purchased a license yesterday and today I still don't see another license in my licenses section on my account. in my orders section it says "in queue". ??? trinna get this flash done. please help.
That license had to get manually added for some reason, but I added it first thing this morning for you.