Support Forum

R6 2018 Auto Blipper error code AIS F1400

werkstatt@yamaha-zentrum-ribnitz.dewerkstatt@yamaha-zentrum-ribnitz.de Posts: 5Verified User
in R6

Hello, we have installed the Auto Blipper on an R6 2018 EU and connected it as described. After flashing the ECU, the FI lamp is burning and the fault memory is fault F1400 (AIS Circuit break). The error is recognized as active and can not be deleted! It should be exchanged PIN 12 at the small ECU plug that is according to PIN assignment the output to the AIS valve. Is it correct that the control should be done via this PIN? If so, it is clear that a fault in the AIS circuit is detected. How can we bypass the error message? Or is it another PIN on the control unit that needs to be used?

Comments

  • jason@ftecu.comjason@ftecu.com Posts: 1,071Staff User

    Hi,

    In the Diagnostic Code Manager you need to uncheck code P1400 then re-flash your ECU.

    Thanks,

    Jason A.

  • monirothvutha@bodiankh.commonirothvutha@bodiankh.com Posts: 9Verified User

    Hi werkstatt

    did u set this up without ground the removed pin 12 from the coupler and inserted the green ftecu QS/AB wire into it?

Sign In or Register to comment.