Support Forum

xsr-900 Bike-Side Flashing Harnesses

josh@ftecu.comjosh@ftecu.com Posts: 8Staff User
edited August 20 in XSR 900

Here is a list of available bike-side flashing harnesses needed for the Yamaha xsr-900 (all xsr-900 flashing kits use a 6-pin DataLink):


6-pin Bike Side Harness Type 11 - 2016-2018 Yamaha XSR 900

(also works for: 2015-2018 Yamaha FJ-09 and 2014-2018 Yamaha FZ/MT-09 and 2018-2019 Yamaha Tracer 900 GT)


**Note: Please carefully select all bench and bike-side harnesses and make certain they work for your bike/ECU before flashing**

Comments

  • Heilmanman52@gmail.comHeilmanman52@gmail.com Posts: 10Verified User

    Hi there, so I havea 16 fz09 everything has been perfevt untill recently and nothing has changed for some time. Just recently i did a "live monitor" saved the file and the wrote it to the ecu. I thought that this would help improve the auto tune accuracy. Then riding to work i noticed a type of a surge not a rough surge but noticeable when holding a steady throttle at low and high speeds. So i tried re flashing with the original fz09 unrestricted file and it is still doing the same. Also the idle seems a little unstable

    Thanks for any help

  • kento_ftecukento_ftecu Posts: 616Staff User

    Please give us more details on your procedure for saving the live monitor trims and saving/writing that file to your ECU.

  • gsbeadle@msn.comgsbeadle@msn.com Posts: 2Verified User

    I've been trying to update some settings and write the ECU but keep getting an error message stating, "No registered ECU found...." Is there something I should be doing differently?

  • gsbeadle@msn.comgsbeadle@msn.com Posts: 2Verified User
    edited July 2020

    So after a few more tries, the ecu is now recognized, but a minute or two into the Write sequence I get a message that reads, "Status: Fail:Analyzing Variables..."

  • jason@ftecu.comjason@ftecu.com Posts: 904Staff User

    Hi,

    I see you successfully flashed the ECU yesterday. Are you good to go now?

    Thanks,

    Jason A.

  • Phuckhead04@gmail.comPhuckhead04@gmail.com Posts: 1Verified User

    Jason@ftecu.com

    I am also getting the surge. What ive done and I hope it makes sence is hook up bike side harness use my last flash turn off auto tune make sure live monitor is on flash go take a short ride come back leave key on hook back to harness ot tells me suggested trims save flash then ise that saved flash to turn auto tune back on and flash. I've done it a few times now and I still get the surge like hellmanman said.

  • charlie@ftecu.comcharlie@ftecu.com Posts: 26Staff User
    https://forum.ftecu.com/discussion/comment/5855#Comment_5855

    Hey,

    Can i have you email us at sales@ftecu.com

Sign In or Register to comment.