Support Forum

Dyno without limp mode?

wrightawayace@gmail.comwrightawayace@gmail.com Posts: 3Verified User
in CBR 1000

Has any one found a way to dyno this bike without the front wheel speed sensor causing it to go into limp mode?

Comments

  • rtijpens@upcmail.nlrtijpens@upcmail.nl Posts: 1Verified User

    If you are on a paddock stand with the engine running or use a dyno the ECU will throw up a fault as it cannot understand why the rear is spinning but front stationary – the fix for this is to do 3 short ½ mile runs consecutively turning the engine off and on each time

  • mattdtaylor85@gmail.commattdtaylor85@gmail.com Posts: 6Verified User

    Is this a verified solution? What's the logic behind performing 3 consecutive 1/2 mile pulls with restarting the bike?

  • paulmcwn@gmail.compaulmcwn@gmail.com Posts: 4Verified User

    Looking to keep this conversation alive. Any news on this? I would like to know the reasoning behind this logic as well.

  • wrightawayace@gmail.comwrightawayace@gmail.com Posts: 3Verified User

    I spliced the front wheel speed sensor wire to the rear wheel sensor. It has been running fine, but I believe the wheelie control and traction control are disabled.

Sign In or Register to comment.