2021 GSXR-1000R hardfail "recovery attemps exceeded"
Flashed fine a couple of times then this message every time. Bike has been in a dead mode and won't start obviously. Really need to fix and get my bike running. Bike side harness, done the checks, everything else is fine. It will read but when it goes to write, I get this message.
Comments
@jason@ftecu.com @kento_ftecu
@mike@ftecu.com
Anyone?
Look for the diagnostic steps where you place a paperclip in the harness, to see if the wiring is still good. Mine did same, R1M tho, by reseating all the wires in the bigger ECU connector my issues went away. I'll try and find them for you..
thanks but the tests were all good. It was the license. It was recognizing as fraud, so it locked up. Mike reset it. Good as new. Bike ran better after honestly. I think it's a good idea to re-flash every now and then.
Ok, good for you! But this is the link to the test I was talking about, which I think you stated "all test were good", so this is for anyone reading this later:
https://forum.ftecu.com/discussion/319/attention-hardware-test-for-6-pin-bike-side-harness-that-will-often-solve-your-issues#latest
@kgsiani@gmail.com Good point. Yeah, I jumped the red/orange..no fuel pump. same with red/yellow...no fuel pump. Steady 5v on Black/Orange, Black/Yellow. Still good to do the test. Also, goes without saying, make sure you guys are loading right part number. I know the ECU is a bitch to get out if you aren't used to it. Believe me, it will safe you some heartburn.
That message is shown when there is a problem flashing and the user keeps trying with out correcting the communication issue. It will not allow another recovery attempt for 10 + days