2018 YZF-R6(eu) Autoblip install problem

jyh9129@naver.com

Hello, I purchased the 2018 YZF-R6(eu) Autoblipper and installed it. According to the manual, the green terminal of the autoblipper was connected after removing pin 12 of the existing ECU, but it does not start after turning on the error code. Even if it gets caught, the engine turns off after the auxiliary phenomenon. It seems to be due to injector error code lighting. (Other than fan relay fault lighting)

Let me tell you what I've done.

1. After mounting the autoblipper, the existing terminal 12 is grounded to the battery-.

2. Autoblipper push, full switch terminal intersection.

3.ECU, flash again.

This is YZF-R6 in Korean specification.

Please provide any solution.

monirothvutha@bodiankh.com

어떻게 문제를 해결하셨나요?